How To Reset Blink Camera To Factory Settings. Insert both batteries back into the camera. Local storage refers to saving clips from your camera system to a usb drive inserted into a sync module.
Local storage refers to saving clips from your camera system to a usb drive inserted into a sync module. If playback doesn't begin shortly, try restarting your device. This mainly helps when some camera settings were altered without your prior knowledge.
Table of Contents
A Hard Reset Will Revert Your Blink Camera To Its Original Factory Settings.
Blink video doorbell, outdoor, indoor (gen 2), and mini. Keep the reset button at the back of the nvr to set everything back to defaults. Grab a pin or paperclip as you'll need this during the process.
Remove Both Batteries From The Camera For 10 Seconds.
Blink video doorbell, outdoor, indoor (gen 2), and mini. To do so, hold a pin in the reset hole on the bottom of the camera for about 10 seconds. Keep it pressed until the light turns red.
A Hard Reset Will Revert Your Blink Camera To Its.
Solid green and blue light will appear once the reset is done. The blink mini has a reset button on the bottom side of the camera, which may be necessary to use when you add it to a new or existing blink system. Once again, after the light turns red, reinstall the sync module in the blink app.
Reset A Zmodo Camera To Factory Settings.
To reset a blink camera, you need to reset the sync module and this can be done by holding down the reset button on the module’s side. Local storage is a blink feature allowing a sync module 2 to save clips from. Nvr and ip cameras #1:
By Factory Resetting The Camera, All Backdrops Will Be Turned To Default.
If you are using a blink mini camera, you can find the reset button at the bottom of the camera. Another troubleshooting step is to restore the blink camera app back to factory settings. Insert both batteries back into the camera.