How To Properly Disconnect And Reconnect A Car Battery. From the november 2015 issue of snowtech magazine. Always have the ground wire disconnected when you are connecting or disconnecting the red positive terminal.
The car is an 84 crossfire vette. Know the right tools to connect a car battery. And if you know how to do that you might be able to save a few bucks.
Table of Contents
And If You Know How To Do That You Might Be Able To Save A Few Bucks.
Turn off the ignition & apply safety procedures. Disconnect first the negative terminal, followed by the positive terminal. If i disconnect the battery to make a change on anything and reconnect the battery, the car will not start.
The Car Is An 84 Crossfire Vette.
Disconnect the negative battery cable and then the positive cable with a combination wrench. Check that everything is secure, then start your car and test the battery. Next, turn on your car and try any of the electric or electronic systems (like a/c or radio) to make sure they work.
This Is To Prevent Sparking Or Shocks That Can Cause Injury Or Damage.
Wear gloves, as this will not only protect your hands, but will also keep the oils on your hands from getting on the battery terminals. From the november 2015 issue of snowtech magazine. But finding a complete guide about that is a bit tough.
Next Put The Key In And Put It To Position Ii And Then From Outside Of The Car (Key Still In Position Ii), Shut All The Doors And Then Reconnect The Battery.this Is The Reset Procedure And May Clear Up The Issue With Electrical Gremlins That.
Apply a thin layer of petroleum jelly to the terminals. A reading under 10 volts indicates a bad battery that needs to be replaced. (september, 2015) subscribe to snowtech and have every issue mailed right to your door, 5 times per year!
Know The Right Tools To Connect A Car Battery.
You actually have to know which one is best for your car. Before you begin, switch the ignition off and remove the key. Before proceeding, double check that your car battery is connected correctly.